Tesseract CAD Tools
CAD Tools

Open a drawing

DWG (any version up to 2018) or DXF. Files are read on this device and never uploaded.

Recently opened files will appear here.

Loading the DWG engine (about 9 MB, cached after the first visit)…

Developed by Tesseract Studio
Suggestions or questions: tools@tesseractstudio.co
Version
Reading file
Large drawings can take a few seconds on a phone.

Properties

Draw order

Model and layouts

Layers

Snap points

Polar tracking

Every the angle step: 0°, step, 2 × step…
Extra angles also tracked, with their opposite (+180°)

Angles go anticlockwise from the right (0° = east, 90° = north). Snap points such as endpoints win when they are close; a dotted green line shows the angle being tracked.

Object snap tracking

How to use: while placing a point, press and hold, drag onto a snap point (an endpoint, midpoint, centre…) and stay there a moment: a small green + marks it as picked up. Move away and the pointer locks onto dotted green lines through that point; with two picked-up points (or one and the polar line from your last point) it locks onto where the lines cross. Pause on a + again to drop it. Up to 4 points; they clear when the tool ends. With a mouse, resting the pointer on a snap point does the same.

Linetype scale

Make dashes bigger or smaller this drawing · screen and PDF

When one dash and gap would be smaller than about 3 px on screen, the line is drawn solid (as in AutoCAD); zoom in or raise this. DXF exports keep the drawing's own linetype scale.

Point style all points in this drawing

% of screen height

Share drawing

PDF

Measurements

Decimal places